Vanguard. Steps 3 & 4

[SheHawk 198]

Vannguard Stage 3

Here I have removed all of the squares and the guide textures, as I no longer need them, I have added an offset, to the over all layout, wich gives me the walls and rooms that will be 3D, once I pull up each part, using the Push/Pull Tool, what that basically does is pull a flat object up down or side ways into a solid 3D object, if it is too big, I can push back in, for teh desired size and width of the model, that I need, hence the name of the tool. Also at this stage, to draw lines as seen in the second image as so to make sections that I can individually pull up.

Vanguard. Stage 5

Talking about pulling up flat shapes etc. The next step after adding an offset to the over all layout, I begin to pull up every section, while this part is time consuming, it is worth the while doing. I hope you all like what I hae shared and showed you so far? And I hope you all lookin g forward to steps 5&6?

Edited December 4, 2019 by SheHawk